LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1424 (Seat Frames (Cabriolet)) >> 72 Seat Frames >> Front Seats >> Entry Assistance Trim, Removing And Installing >> Entry Assistance Trim, Removing And Installing, Power >> Removing

Entry Assistance Trim, Removing And Installing, Power: Removing

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Prying Trim -1- Out Of Handle Upward Using 3409 -Arrows B
GWWA72-11061Courtesy of AUDI OF AMERICA, LLC

-- Press the handle -2- -arrow- forward until it stops and hold it in that position.

-- Remove the strap from the tab with a screwdriver.

-- At the same time, pry the trim -1- out of the handle with the bracket upward using the :3409  -arrows B-.

-- Disengage the rear trim catch from the handle with bracket.

-- Remove the trim from the handle with bracket as much as the length of the entry assistance button wire will allow.

-- Disconnect the connector -1- on the entry assistance button -2-.

Fig 2: Identifying Entry Assistance Button
GWWA72-10762Courtesy of AUDI OF AMERICA, LLC

-- Remove the trim -3- with the entry assistance button.

-- Remove the entry assistance button. Refer to ENTRY ASSISTANCE BUTTON, REMOVING AND INSTALLING .