Windshield Washer Pump, Removing And Installing: Removing
WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
-- Turn off the ignition and remove the key.
-- Remove the left front wheel.
-- Remove the left front wheel housing liner. Refer to WHEEL HOUSING LINER .
-- Disconnect the connector -4-.
-- Place a drip tray under the windshield washer fluid reservoir.
-- Release the securing clip -2- in the direction of the -arrow- and remove the washer fluid line -1- from the windshield washer system washer fluid pump.
-- Remove the Windshield Washer Pump -V5- -3- upward out of the washer fluid reservoir.
NOTE:
Courtesy of AUDI OF AMERICA, LLC
Replace the Windshield Washer Pump -V5- bracket -1- if it is damaged.
Fig 2: Pressing Damaged Bracket -1- Out Of Mount In Washer Fluid Reservoir -2- Toward Outside Of Vehicle -Arrow-
Push the damaged bracket out of the mount in the windshield washer fluid reservoir -2- -arrow-.