Overview - Windshield Washer System: Notes
WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- Tightening sequence. Refer to Figure
- O-Ring
- Replace if damaged.
- Grommet
- Replace if damaged.
- Filler Tube
- For the windshield washer fluid reservoir
- Removing and installing. Refer to WASHER FLUID RESERVOIR FILLER TUBE, REMOVING AND INSTALLING .
- Support Ring
- Nut
- Tightening specification. Refer to SUSPENSION STRUT AND UPPER CONTROL ARM
- Threaded connection shared with tower brace
- Cap
- For the filler neck
- Windshield Washer Fluid Hose
- For the windshield washer system
- Right Spray Nozzle
- Depending on vehicle equipment with Right Washer Nozzle Heater -Z21-
- Removing and installing. Refer to SPRAY NOZZLES, REMOVING AND INSTALLING .
- Adjusting. Refer to appropriate service information
- Left Spray Nozzle
- Depending on vehicle equipment with Left Washer Nozzle Heater -Z20-
- Removing and installing. Refer to SPRAY NOZZLES, REMOVING AND INSTALLING .
- Adjusting. Refer to appropriate service information.
- Windshield Washer Fluid Reservoir
- Removing and installing. Refer to WINDSHIELD WASHER FLUID RESERVOIR, REMOVING AND INSTALLING .
- Headlamp Washer Pump -V11-
- Grommet
- Windshield Washer Fluid Hose
- For the headlamp washer system
- Retaining Ring
- For Windshield Washer Pump -V5-
- Windshield Washer Pump -V5-
- Removing and installing. Refer to WINDSHIELD WASHER PUMP, REMOVING AND INSTALLING .
- Grommet
- Bolt
- Tightening sequence. Refer to Figure
- Grommet
- Windshield Washer Fluid Level Sensor -G33-
- Removing and installing. Refer to WINDSHIELD WASHER FLUID LEVEL SENSOR, REMOVING AND INSTALLING .