Clutch Measurement
WARNING: This page is about a different car, the 2014 Audi A5, 2013 Audi A5, 2012 Audi A5, and 2011 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The distance -K- of the clutch from the upper shim to the contact ring on the shaft (press plate contact surface) is determined.
The corrugated spring washer -1- is installed under the clutch plate pack to perform measurements.
- All components must be cleaned thoroughly before inserting.
-- Place the input shaft on the :T10219/1 .
-- Insert the new lower shim -1- with the same thickness as the old shim in the input shaft cylinder -A-.
-- Insert the corrugated spring washer -2-.
NOTE:
The corrugated spring washer is installed at the bottom only for measurement; it is installed back at the upper position during assembly.
-- Insert now alternating in the same direction per lining plate -3- and outer clutch plate -4-.