LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1404 (Wiring (Cabriolet)) >> 97 Wiring >> Relay Carriers, Fuse Panels And E-Boxes >> Fuse Panel On Right Side Of Instrument Panel, Removing And Installing >> Right Instrument Panel Fuse Carrier, Removing And Installing >> Removing

Right Instrument Panel Fuse Carrier, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Fuse Panel D, With Right Instrument Panel Fuse Panel Components
GWWA97-10343Courtesy of AUDI OF AMERICA, LLC

-- With the ignition switched off, disconnect the battery ground cable. Refer to BATTERY, DISCONNECTING AND CONNECTING .

-- Remove the glove compartment. Refer to appropriate service information .

-- Release the clips -1- in the direction of the -arrow- and press the fuse carriers -2- and -3- toward the rear and out of the fuse panel D.

NOTE:

Ignore item -4-.

-- Unlock the release and remove from the fuse carrier, if equipped.

Fig 2: Releasing Clips And Removing Cover From Fuse Holder
GWWA97-10014Courtesy of AUDI OF AMERICA, LLC

-- Remove the fuses from the fuse panel.

-- Release the retaining clips -arrows- and remove the cover from the fuse carrier.

-- Remove the connector retaining strip -1- -arrow- and remove the connectors from the plug-in socket.

Fig 3: Pulling Off Retaining Strip
GWWA97-10015Courtesy of AUDI OF AMERICA, LLC
NOTE:

For the exact assignment of right instrument panel fuse panel. Refer to the appropriate wiring diagram(s).