Air Intake Duct, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Installation is carried out in the reverse order while Observing The Following.

-- Insert the air intake duct -B- into the brackets -C- on the air intake housing -C- and join both parts together.

NOTE:

If one of the retaining tabs -A- has broken off or if one of the welded points no longer holds, both housing parts can be bolted together with screws -D-.

-- Install the removed parts in the opposite order.

-- Perform a basic setting and the output diagnostic test mode for the A/C system using the Vehicle Diagnostic Tester in the "Guided Fault Finding" function.

-- Check the DTC memory for the Climatronic Control Module -J255- display and control head and erase any displayed malfunctions, if necessary using the Vehicle Diagnostic Tester in the "Guided Fault Finding" function.