LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1379 (Front Suspension (Front Axle - Drive Axle) (Cabriolet)) >> 40 Front Suspension >> Lower Control Arm And Ball Joint >> Control Arm Ball Bearing, Replacing >> Bearing, Removing

Bearing, Removing

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Hold Track Control Arm Firmly In Position While Pressing Bearing Out And In
GWWA40-10245Courtesy of AUDI OF AMERICA, LLC

-- Mark the installation depth -arrow- on the bearing -1-.

Use A Waterproof Felt-Tip Pen.

-- Install the special tools as shown in the illustration.

  1. :VW412 
  2. :T10030/1 
  3. Bracket
  4. Control Arm
  5. :3301/3 
  6. :3301/1 
  7. :VW402 

-- Press bearing -3- out of track control arm -4-.



Fig 1: Hold Track Control Arm Firmly In Position While Pressing Bearing Out And In
GWWA40-10248Courtesy of AUDI OF AMERICA, LLC

-- Mark the installation depth -arrow- on the bearing -3-.

Use A Waterproof Felt-Tip Pen.

-- Install the special tools as shown in the illustration.

  1. :VW412 
  2. :3346 
  3. Bracket
  4. Control Arm
  5. :3301/4 
  6. :3301/1 
  7. :VW402 

-- Press bearing -3- out of track control arm -4-.

scientia non olet · About LEMON Manuals