Power Steering Pump, Vehicles Without Dynamic Steering [CAEB, CPMA]: Overview

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Always replace seals.

Do not reuse fluid you have drained.

Only use hydraulic oil.

Fig 1: Exploded View Of Power Steering Pump, Without Dynamic Steering (4-Cylinder TFSI)

Courtesy of AUDI OF AMERICA, LLC

Bracket
Sleeve
- Drive the sleeve back slightly to install the power steering pump.
Bolt
- 25 Nm
Bolt
- 9 Nm
Pressure Line
CAUTION:
- Insert the pressure line completely when installing.
Seal
- Always replace if removed.
Intake hose
- The marking "P" on the suction hose -arrow- must align with the formed seam -arrow- on the power steering pump.
Clamp
- Tension using hose clamp pliers:V.A.G 1275 .
- Always replace if removed.
Power Steering Pump
- Allocation, refer to the Parts Information.
- Fill with hydraulic oil before installation.
- Checking delivery pressure, refer to POWER STEERING PUMP, CHECKING DELIVERY PRESSURE [CAEB, CPMA] .
- Removing and installing, refer to REMOVING .
- Bleed the steering. Refer to STEERING, BLEEDING AFTER REPLACING .
- Check hydraulic fluid level. Refer to POWER STEERING FLUID LEVEL, CHECKING .
- Steering system, checking for leaks, refer to STEERING, CHECKING FOR LEAKS .
Bolt
- 25 Nm