Tie Rod End: Removing

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

-- Place the vehicle on a hoist.

-- Remove the wheel.

-- Measure the dimension -a- between the tie rod head -2- and the left and right tie rod -1- and make a note of the value. Dimension -a- must be the same on the left and right sides after installing.

Fig 1: Measuring Tie Rod / Tie Rod Head Dimension

Courtesy of AUDI OF AMERICA, LLC

-- If necessary, shorten the "longer" tie rod head (installed it deeper into the tie rod).

-- Remove the nut -1- from the tie rod end joint pin -2- until it is flush with the joint pin threads. Counterhold when loosening.

Fig 2: Identifying Tie Rod End Joint Pin

Courtesy of AUDI OF AMERICA, LLC

To protect thread, screw nut on pin a few turns.

Fig 3: Removing Tie Rod Ball Joint

Courtesy of AUDI OF AMERICA, LLC

-- Press off track rod ball joint from wheel bearing housing using :T40010 A . Remove the nut.

NOTE:

Make sure that both puller lever arms are parallel to each other when using greatest force, adjust if necessary.

-- Loosen the nut -2-. Counterhold the tie rod end -3-.

Fig 4: Identifying Tie Rod End & Nut

Courtesy of AUDI OF AMERICA, LLC

-- Remove the tie rod end -3-.