LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1374 (Interior Trim (Cabriolet)) >> 70 Interior Trim >> Convertible Top Compartment >> Guide Rail For Variable Convertible Top Compartment Enclosure, Removing And Installing >> Removing

Guide Rail For Variable Convertible Top Compartment Enclosure, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Convertible Top Compartment Cover Locking Motor -V222-
GWWA70-11083Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Open the convertible top until the displayed position of the top and the convertible top compartment cover is reached.

-- Support the convertible top with a suitable wood rod.

-- Pull the front spring motor -2- on the variable convertible top compartment in the left and right guide rail -1- all the way up.

Fig 2: Pulling Front Spring Motor -2- On Variable Convertible Top Compartment In Left And Right Guide Rail -1- All Way Up
GWWA70-11104Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Release the hooks on the left and right guide rail using a small screwdriver -arrow-.

-- Pull the front spring motor -2- on the variable convertible top compartment enclosure in the guide rail -1- up to the second stop.

Fig 3: Pulling Front Spring Motor -2- On Variable Convertible Top Compartment Enclosure In Guide Rail -1- Up To Second Stop
GWWA70-11105Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Insert a 1 mm diameter pin (such as a paper clip) -3- into the left and right holes in the spring motor.

WARNING:
  • If the spring motor is not locked, the spring is released and axle turns 24 times.
  • Spring motors without tension can be retightened by turning the axle 24 times from clockwise from the left.

-- Release the hooks on the left and right guide rails with a small screwdriver -arrow-, and pull the spring motor to the upper edge of the guide rail (do not disengage).

-- Repeat the procedure on the other side of the vehicle.

-- Disengage the front variable convertible top compartment enclosure on the left and right side from the guide rails and set it down.

-- Remove the fleece -1- on the guide rail.

Fig 4: Removing Fleece -1- On Guide Rails
GWWA70-11093Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the bolts -2, 3, 5 and 6- and remove the guide rail -4-.