Electromechanical Parking Brake Control Module -J540-, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

-- Connect the connector -2- to the control module.

Fig 1: Connecting Electrical Connectors On Control Module

Courtesy of AUDI OF AMERICA, LLC

-- Slide the retainer on the connector back and lock it.

-- Insert the control module.

-- Install the nuts and tighten to 9 Nm.

Install the trailer towing control module and bracket, if applicable. Bracket: 3 Nm.

-- If the electronic parking brake control module is replaced, select the "Replace" function for the respective control module in "Guided Fault Finding".

Use the Vehicle Diagnostic Tester.