Brake Rotor, Removing And Installing, 1LM: Installing

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Replace the bolts -1 and 13-.

Fig 1: Identifying Bolt -1- And Brake Caliper, Installation

Courtesy of AUDI OF AMERICA, LLC

Clean the brake rotor, wheel hub and contact surfaces before installing.

-- Place the brake rotor on the wheel hub.

NOTE:

When positioning the brake rotor, do not tilt it on the wheel hub.

-- Install the bolt -1- and tighten it to 9 Nm.

Fig 2: Identifying Bolt -1- And Brake Caliper, Installation

Courtesy of AUDI OF AMERICA, LLC

-- Install the brake caliper. Refer to BRAKE CALIPER, REMOVING AND INSTALLING, 1LM .

-- Install The Wheels.

Wheel bolt tightening specification. Refer to WHEEL BOLT TIGHTENING SPECIFICATIONS .

CAUTION:

After the first drive, depress brake pedal firmly several times with vehicle stationary so that the brake pads are properly seated in their normal operating position.

CAUTION:

Make sure the brakes are working correctly before driving the vehicle for the first time.