Brake Pads, Removing And Installing, 1LT And 1LY: Removing

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

-- Raise The Vehicle.

-- Remove the wheels.

NOTE:

Label the brake pads when removing if they are going to be used again. Install in the same position, otherwise the braking effect will be uneven.

-- Remove the caps -13-.

Fig 1: Identifying Brake Caliper Components

Courtesy of AUDI OF AMERICA, LLC

-- For vehicles with the brake wear pad indicator, disconnect the left front connector -4-.

-- Lift the securing strap slightly at bottom of connector and then rotate 90°.

-- Remove the lower section of the brake pad wear indicator connector from the bracket.

-- Using the screwdriver, pry off the brake pad spring from the brake caliper housing and remove.

Fig 2: Identifying Brake Pad Retaining Spring From Brake Caliper Housing

Courtesy of AUDI OF AMERICA, LLC

-- Loosen and remove both guide pins -12- from the brake caliper.

Fig 3: Identifying Caliper Guide Pins, Removal/Installation

Courtesy of AUDI OF AMERICA, LLC

Mount the brake caliper on the vehicle using a suitable wire. Do not support the weight with the brake hose.

-- Remove the brake pad from the brake caliper housing or from the brake carrier.