Bumper Cover, Removing And Installing, AUDI RS5: Removing

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Front Noise Insulation And Fasteners

-- Remove the front noise insulation. Refer to NOISE INSULATION, REMOVING AND INSTALLING, AUDI RS5 .

-- Remove the bolts -arrows- .

-- Remove the front wheel housing liner. Refer to FRONT WHEEL HOUSING LINER, REMOVING AND INSTALLING, AUDI RS5 .

Fig 2: Lock Carrier Bolts

-- Remove the bolts -arrows- .

-- Remove the lock carrier cover. Refer to LOCK CARRIER COVER, REMOVING AND INSTALLING .

Fig 3: Identifying Front Parking Aid Sensor Connector -1-

-- Disconnect the connector -1- for the front parking aid sensor.

-- In equipped, remove the Garage Door Opener Control Module - J530- -2- . Refer to Contact Release Tools Connector Housings, Releasing and Disassembling .

-- Remove the bolts -arrows- .

-- Disengage the side walls on the front side panel and remove the bumper cover forward.