LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1151 (Safety Belt System) >> General Procedures >> Seatbelt Procedure After a Collision

Seatbelt Procedure After a Collision

WARNING: This page is about a different car, the 2018 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.

Inspection 

WARNING: All seatbelt components must be inspected and corrected as part of any collision repair. Inspect all seatbelt components as prescribed by Seatbelt Procedure After a Collision found in GENERAL PROCEDURES . Failure to follow this instruction may result in incorrect operation of the seatbelt system and increase the risk of serious personal injury or death in a crash.
  1. Before installing the new seatbelt assembly, inspect the seatbelt attaching areas for damage and distortion. If the attaching points are damaged and distorted, work the sheet metal back to its original shape and structural integrity.
  2. Install new seatbelt(s) at any seating position(s) where deployment has occurred and the seatbelt(s) were used. Carry out the appropriate Functional Test procedure for all seating positions. Refer to: Component Test .
scientia non olet · About LEMON Manuals