Rear Door Glass Run and Bracket: Removal

WARNING: This page is about a different car, the 2018 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: LH side shown, RH side similar.

NOTE: Removal steps in this procedure may contain installation details.

Aft rear door glass run and bracket

Remove the rear door trim panel. Refer to: Rear Door Trim Panel .
Remove the watershield.

Courtesy of FORD MOTOR COMPANY
Remove the aft rear door glass run and bracket.
1. Remove the bolts from the aft rear door glass run and bracket.
  Torque
  
  : 71 lb.in (8 Nm)
2. Remove the aft rear door glass run and bracket.
Courtesy of FORD MOTOR COMPANY

Fore rear door glass run and bracket
Remove the rear door trim panel. Refer to: Rear Door Trim Panel .
Remove the rear door speaker.
1. Disconnect the wiring harness electrical connector from the rear door speaker.
2. Remove screws and the rear door speaker.
  Torque: 22 lb.in (2.5 Nm)
Courtesy of FORD MOTOR COMPANY
Remove the fore rear door glass run and bracket.
1. Remove the fore rear door glass run and bracket bolts.
  Torque
  
  : 71 lb.in (8 Nm)
2. Remove the fore rear door glass run and bracket.

Courtesy of FORD MOTOR COMPANY