LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1142 (Seating System - Front (2 Of 2)) >> Removal And Installation >> Front Seat Cushion Blower Motor >> Removal

Front Seat Cushion Blower Motor: Removal

WARNING: This page is about a different car, the 2018 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Driver seat shown, passenger seat similar.
  1. Raise the seat to the full up position.
    GFD275133Courtesy of FORD MOTOR COMPANY
  2. Depower the SRS. Refer to: Supplemental Restraint System (SRS) Depowering .
    1. Disconnect the front seat cushion blower motor electrical connector.
    2. Detach the front seat cushion blower motor wiring harness retainer from the seat cushion suspension.
    3. Rotate the front seat cushion blower motor 45 degrees clockwise to unlock from the seat cushion suspension.
    GFD275128Courtesy of FORD MOTOR COMPANY
  4. Remove the front seat cushion blower motor.
GFD275129Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals