LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1142 (Seating System - Front (2 Of 2)) >> Removal And Installation >> Front Seat Backrest Blower Motor >> Removal

Front Seat Backrest Blower Motor: Removal

WARNING: This page is about a different car, the 2018 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Driver seat shown, passenger seat similar.
NOTE: Seat shown removed from vehicle for clarity.
  1. Depower the SRS. Refer to: Supplemental Restraint System (SRS) Depowering .
    1. On both sides.Detach the front seat backrest assembly from the backrest module retainers. Use the General Equipment: Interior Trim Remover.
    2. On both sides.Detach the front seat backrest assembly from the backrest module retainers. Use the General Equipment: Interior Trim Remover.
    3. Fold the upper portion of the front seat backrest to access the front seat backrest blower motor.
    GFD274592Courtesy of FORD MOTOR COMPANY
  3. Remove the front seat backrest blower motor.

    1. Disconnect the electrical connector.
    2. Rotate the front seat backrest blower motor 45 degrees clockwise to unlock it from the seat backrest carrier.

GFD275115Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals