Rear Door Upper Moulding: Removal
WARNING: This page is about a different car, the 2018 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
LH side shown, RH side similar.
Fore Rear Door Upper Moulding
- Lower the door window glass.
- Remove the upper belt moulding screw at rear of the door.
- Remove the pin type retainers and position aside the rear door weatherstrip at front of rear door.
- Remove the upper belt moulding screw at front of the door.
- Using a non-marring trim tool, disengage the moulding from the channel in the door and remove the moulding.
- Remove the rear door trim panel. Refer to: REAR DOOR TRIM PANEL .
- Remove the pin-type retainers and the upper interior rear door trim.
- position aside the rear door fore top run weatherstrip.
- Remove the screws.
- Detach the front edge of the moulding from the door frame and pull the moulding outward to remove.
Aft Rear Door Upper Moulding
- Lower the door window glass.
- Remove the upper belt moulding screw at rear of the door.
- Remove the pin type retainers and position aside the rear door weatherstrip at front of rear door.
- Remove the upper belt moulding screw at front of the door.
- Using a non-marring trim tool, disengage the moulding from the channel in the door and remove the moulding.
- Remove the rear door glass top run. Refer to: REAR DOOR GLASS TOP RUN .
- Remove the screws.
Torque: 13 lb.in (1.5 Nm)
- Remove the rear door rear moulding.