LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1139 (Exterior Trim And Ornamentation) >> Diagnosis And Testing >> Power Running Board (PRB) >> Pinpoint Tests >> Pinpoint Test G : U0146 >> Notes

Pinpoint Test G : U0146: Notes

WARNING: This page is about a different car, the 2018 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.

Refer to Wiring Diagram Module Communications Network for schematic and connector information.

Normal operation and Fault Conditions 

With normal battery voltage and the ignition ON, the GWM sends messages to the RBM over the MS-CAN. If the RBM does not receive these messages within a certain time frame, the RBM sets a DTC. For information on the messages sent to the RBM by the GWM, refer to the Network Message Chart. REFER to: Power Running Board (PRB) - System Operation and Component Description .

DTC Fault Trigger Conditions 

DTC Description Fault Trigger Conditions
U0146 Lost Communication with Gateway "A": No Sub Type Information This DTC sets if messages received from the GWM are missing for 5 seconds or more.

Possible Sources