LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1138 (Interior Trim And Ornamentation) >> Removal And Installation >> Liftgate Trim Panel >> Removal

Liftgate Trim Panel: Removal

WARNING: This page is about a different car, the 2018 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release the clips and remove the liftgate upper middle trim panel.
    GFD274939Courtesy of FORD MOTOR COMPANY
  2. NOTE: LH shown, RH similar.

    On both sides. Release the clips and remove the liftgate side trim panel.

    GFD274940Courtesy of FORD MOTOR COMPANY
  3. Release the tabs and remove the liftgate handle bolt cover.
    GFD274941Courtesy of FORD MOTOR COMPANY
  4. Remove the liftgate handle bolts.
    GFD274942Courtesy of FORD MOTOR COMPANY
  5. Release the liftgate trim panel clips.
    GFD274943Courtesy of FORD MOTOR COMPANY
  6. Remove the liftgate trim panel.

    1. Lift upward on the liftgate trim panel.
    2. Disconnect the liftgate interior light electrical connector.
    3. If equipped. Disconnect the power liftgate switch electrical connector.

GFD274944Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals