Passive Anti-Theft System (PATS) Center Antenna: Removal

WARNING: This page is about a different car, the 2018 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.

Release the clips and remove the floor console front trim panel. Use the General Equipment: Interior Trim Remover

Courtesy of FORD MOTOR COMPANY
Remove the floor console finish panel bolts.

Courtesy of FORD MOTOR COMPANY
Position the floor console armrest.

Courtesy of FORD MOTOR COMPANY
On both sidesRelease the clips and remove the floor console finish panel. Use the General Equipment: Interior Trim Remover

Courtesy of FORD MOTOR COMPANY
On both sidesRelease the clips and remove the floor console side trim panel. Use the General Equipment: Interior Trim Remover

Courtesy of FORD MOTOR COMPANY
On both sides.Remove the bolts.

Courtesy of FORD MOTOR COMPANY
Release the clips and position the floor console rear trim panel aside. Use the General Equipment: Interior Trim Remover

Courtesy of FORD MOTOR COMPANY
Disconnect the electrical connectors and remove the floor console rear trim panel.

Courtesy of FORD MOTOR COMPANY
Remove the PATS center antenna.
1. Remove the screws.
2. Position the PATS center antenna aside.
3. Disconnect the electrical connector.

Courtesy of FORD MOTOR COMPANY