DTC Chart: BCM
WARNING: This page is about a different car, the 2018 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.
Diagnostics in this article assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods .
| DTC | Description | Action |
|---|---|---|
| B10C7:01 | Interior Trunk Antenna: General Electrical Failure | GO to Pinpoint Test A |
| B10C9:01 | Interior Front Antenna: General Electrical Failure | GO to Pinpoint Test A |
| B10D7:05 | PATS Key: System Programming Failure | DIAGNOSE all other Diagnostic Trouble codes (DTCs) first. If no other Diagnostic Trouble codes (DTCs) are present, PROGRAM the suspect passive key again. If key programming fails, REPLACE the suspect passive key. PROGRAM the new passive key. REFER to:Anti-Theft Key Programming - Scan Tool Components Location . |
| B10D7:55 | PATS Key: Not Configured | The CEI was not completed during the PMI procedure. PERFORM the CEI as part of the PMI procedure. |
| B10D8:00 | PATS Key Less Than Minimum Programmed: No Sub Type Information | Less than 2 keys are programmed (minimum of 2 keys must be programmed). PROGRAM the customer's second key. REFER to:Anti-Theft Key Programming - Scan Tool . |
| B10DA:51 | PATS Target Identifier: Not Programmed | There is no PCM ID stored in the BCM memory. PERFORM a parameter reset. REFER to:Anti-Theft Key Programming - Scan Tool . |
| All other Diagnostic Trouble Codes (DTCs) | - | REFER to:MULTIFUNCTION ELECTRONIC MODULES . |