Video Display: Removal

WARNING: This page is about a different car, the 2018 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Driver seat shown, passenger seat similar.

NOTE: Seat shown out of vehicle for clarity.

1. On both sides. Detach the front seat backrest assembly from the backrest module retainers. Use the General Equipment: Interior Trim Remover.
2. On both sides. Detach the front seat backrest assembly from the backrest module retainers. Use the General Equipment: Interior Trim Remover.
3. Fold the upper portion the front seat backrest.
Courtesy of FORD MOTOR COMPANY
Disconnect the connectors and route the wiring through the grommets.

Courtesy of FORD MOTOR COMPANY
Remove the access panel. Use the General Equipment: Interior Trim Remover

Courtesy of FORD MOTOR COMPANY
Remove the screws and position the video screen up and out.

Courtesy of FORD MOTOR COMPANY
Separate the wiring harness from the seat frame and remove the video display.

Courtesy of FORD MOTOR COMPANY