LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1120 (Information System And Entertainment Systems - General Information (2 Of 2)) >> Removal And Installation >> Front Controls Interface Module (FCIM) >> Removal

Front Controls Interface Module (FCIM): Removal

WARNING: This page is about a different car, the 2018 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release the clips and renove the front floor console trim panel. Use the General Equipment: Interior Trim Remover.
    GFD271162Courtesy of FORD MOTOR COMPANY
  2. Remove the bolts.
    GFD274550Courtesy of FORD MOTOR COMPANY
  3. On both sides.Release the clips and remove the upper bezel. Use the General Equipment: Interior Trim Remover.
    GFD274551Courtesy of FORD MOTOR COMPANY
  4. Position the floor console armrest.
    GFD274552Courtesy of FORD MOTOR COMPANY
  5. Remove the front upper console trim panel screws.
    GFD274503Courtesy of FORD MOTOR COMPANY
  6. Remove the upper console trim panel.

    1. On both sides. Remove the screws.
    2. On both sides. Release the clips.
    3. Disconnect the electrical connectors and separate the wire harness guide.

    GFD274504Courtesy of FORD MOTOR COMPANY
  7. Remove the screws and the trim panel bezel.
    GFD274557Courtesy of FORD MOTOR COMPANY
  8. Remove the screws and the FCIM.
GFD274558Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals