Center Registers: Removal

WARNING: This page is about a different car, the 2018 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Removal steps in this procedure may contain installation details.

Release the clips and remove the FDIM bracket cover. Use the General Equipment: Interior Trim Remover.

Courtesy of FORD MOTOR COMPANY
Remove the bolt and disconnect the LVDS connector.
Torque: 80 lb.in (9 Nm)

Courtesy of FORD MOTOR COMPANY
Remove the center register trim panel. Use the General Equipment: Interior Trim Remover.

Courtesy of FORD MOTOR COMPANY
Remove the bolts and position the FDIM and center register forward as an assembly.
Torque: 22 lb.in (2.5 Nm)

Courtesy of FORD MOTOR COMPANY
On both top and bottom of the center register.Release the clips and position the FDIM off the center register.

Courtesy of FORD MOTOR COMPANY
Disconnect the electrical connector and remove the center register.

Courtesy of FORD MOTOR COMPANY