LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1094 (Automatic Transmission - 10R80 (2 Of 2)) >> Removal And Installation >> Transmission Support Insulator >> Removal

Transmission Support Insulator: Removal

WARNING: This page is about a different car, the 2018 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting .
  2. Remove the transmission support crossmember. Refer to: Transmission Support Crossmember .

    Rear Wheel Drive (RWD) vehicles 

  3. Remove the bolt and the LH isolator cap.
    GFD273633Courtesy of FORD MOTOR COMPANY
  4. Remove and discard the transmission support insulator bolts and washers.
    GFD273634Courtesy of FORD MOTOR COMPANY
  5. Remove the transmission support insulator.
    GFD273635Courtesy of FORD MOTOR COMPANY

    Four-Wheel Drive (4WD) vehicles 

  6. Remove the bolt and the LH isolator cap.
    GFD273636Courtesy of FORD MOTOR COMPANY
  7. Remove and discard the transmission support insulator bolts.
    GFD273637Courtesy of FORD MOTOR COMPANY
  8. Remove the transmission support insulator.
GFD273638Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals