LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1094 (Automatic Transmission - 10R80 (2 Of 2)) >> Removal And Installation >> Transmission Control Module (TCM) >> Removal

Transmission Control Module (TCM): Removal

WARNING: This page is about a different car, the 2018 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The TCM is located on the RH frame rail.
  1. With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting .
  2. NOTE: This step is only necessary when installing a new component.

    Download the module information to the diagnostic tool using the PMI routine. Refer to: Module Programming .

  3. Remove the retainers and the TCM shield.
    GFD273573Courtesy of FORD MOTOR COMPANY
  4. NOTE: Keep the TCM electrical connector straight when connecting it or damage the connector terminals can occur.

    • Slide the lock tab up and disconnect the TCM electrical connector.

    • Detach the TCM wiring harness retainer and position aside

    • Remove the nuts and the TCM.

GFD273574Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals