Engine Oil Pressure (EOP) Sensor: Removal
WARNING: This page is about a different car, the 2018 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.
- With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting .
- If equipped, remove the underbody shield.
Torque: 71 lb.in (8 Nm)
- Remove the LH fender splash shield. Refer to: FENDER SPLASH SHIELD .
- Disconnect the electrical connector and remove the EOP sensor.
Torque:
Stage 1: 133 lb.in (15 Nm)
Stage 2: 185°