Ignition Coil-On-Plug: Removal

WARNING: This page is about a different car, the 2018 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.

Both sides

Remove the engine appearance cover retainers, release the engine appearance cover from the rear retainers and then remove the engine appearance cover.

Courtesy of FORD MOTOR COMPANY

Left side
Disconnect the electrical connector, then disconnect the crankcase ventilation tube and move it out of the way. Refer to:QUICK RELEASE COUPLING .

Courtesy of FORD MOTOR COMPANY

Both sides
Disconnect the ignition coil-on-plug electrical connectors.

Courtesy of FORD MOTOR COMPANY
NOTE: Use compressed air to remove any foreign material from the ignition coil-on-plugs and surrounding area before removing the ignition coil-on-plugs.

NOTE: When removing the ignition coil-on-plugs, a slight twisting motion will break the seal and ease removal.
1. Remove the ignition coil-on-plug retainers.
2. Remove the ignition coil-on-plugs.

Courtesy of FORD MOTOR COMPANY