LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1089 (Starting System - 3.5L ECOBOOST (272KW/370PS)) >> Diagnosis And Testing >> Starting System >> DTC Charts >> PCM DTC Chart

PCM DTC Chart

WARNING: This page is about a different car, the 2018 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.
DTC Description Action
P06E4 Control Module Wake-up Circuit Performance RETRIEVE and RECORD all CMDTCs. If BCM DTC C113A:11 or C113A:15 is found, GO to Pinpoint Test C  Clear all Diagnostic Trouble Codes (DTCs). RERUN the PCM self-test. If the DTC returns, CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If no Technical Service Bulletins (TSBs) address this concern, INSTALL a new PCM. REFER to: Powertrain Control Module (PCM) .
P06E9 Engine Starter Performance If the engine cranks, Refer to ENGINE CONTROLS - INTRODUCTION (EXCEPT DIESEL & HYBRID) . If the engine does not crank, GO to Pinpoint Test A 
P162F Starter Motor Disabled - Engine Crank Time Too Long This DTC sets in the PCM when the engine has been cranked for more than a total of 60 seconds without allowing sufficient time for the starter to cool. Diagnose all other DTCs and symptoms. Check the charging system voltage and correct as necessary. Clear the DTC.
P2534 Ignition Switch Run/Start Position Circuit Low GO to Pinpoint Test D 
P2535 Ignition Switch Run/Start Position Circuit High GO to Pinpoint Test D 
All Other DTCs - REFER to: Electronic Engine Controls .