Removal And Installation: Thermostat: Removal
WARNING: This page is about a different car, the 2018 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Removal steps in this procedure may contain installation details.
- Drain the cooling system. Refer to:Cooling System Draining, Vacuum Filling and Bleeding .
- Remove the air cleaner outlet pipe. Refer to:AIR CLEANER OUTLET PIPE .
- Disconnect PCV hose from CAC outlet tube.
-
NOTE: During installation, make sure the coolant outlet connection is fully seated on the thermostat housing before tightening the bolts.
Remove the bolts and position the coolant outlet connector aside.
Torque: 89 lb.in (10 Nm)
- Remove the thermostat and discard the O-ring seal.