LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1085 (Engine Cooling - 3.5L ECOBOOST (272KW/370PS)) >> Removal And Installation >> Thermostat >> Installation

Removal And Installation: Thermostat: Installation

WARNING: This page is about a different car, the 2018 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.
    1. NOTE: Use Motorcraft® Orange Antifreeze/Coolant for vehicles built up to 08-July-2018 and Motorcraft® Yellow Antifreeze/Coolant for vehicles built from 09-July-2018. Failure to use the correct coolant can degrade corrosion protection.

      Install a new O-ring seal and lubricate it with clean engine coolant.

      Material: Motorcraft® Orange Concentrated Antifreeze/Coolant / VC-3-B (WSS-M97B44-D)

      Material: Motorcraft® Yellow Concentrated Antifreeze/Coolant / VC-13-G (WSS-M97B57-A1)

    2. To install, reverse the removal procedure.
  1. Fill and bleed the cooling system. Refer to:Cooling System Draining, Vacuum Filling and Bleeding .