Crankshaft Front Seal: Installation

WARNING: This page is about a different car, the 2018 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.

Lubricate the crankshaft front seal bore with clean engine oil.
Material

: Motorcraft® SAE 5W-30 Synthetic Blend Motor Oil / XO-5W30-QSP (WSS-M2C946-A)

Courtesy of FORD MOTOR COMPANY
Using the special tools, install the crankshaft front seal.Use Special Service Tool: 303-102 Installer, Crankshaft Pulley., 303-1251 Installer, Front Seal.

Courtesy of FORD MOTOR COMPANY
Lubricate the crankshaft front seal and the crankshaft pulley with clean engine oil.
Material: Motorcraft® SAE 5W-30 Synthetic Blend Motor Oil / XO-5W30-QSP (WSS-M2C946-A)

Courtesy of FORD MOTOR COMPANY
Using the special tools, install the crankshaft pulley.Use Special Service Tool: 303-102 Installer, Crankshaft Pulley.

Courtesy of FORD MOTOR COMPANY
Using the strap wrench, install the new crankshaft bolt and the washer and tighten in 3 stages. Use the General Equipment: Strap Wrench.
Torque:

Stage 1: 37 lb.ft (50 Nm)

Stage 2: 90°

Stage 3: 60°

Courtesy of FORD MOTOR COMPANY
Install the A/C compressor belt. Refer to: Air Conditioning (A/C) Compressor Belt .
After completing the repairs, perform the Misfire Monitor Neutral Profile Correction procedure using a diagnostic scan tool.