LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1082 (Steering Wheel And Column Electrical Components) >> Diagnosis And Testing >> Steering Wheel and Column Electrical Components >> Pinpoint Tests >> Pinpoint Test K : U300A:01 >> Notes

Pinpoint Test K : U300A:01: Notes

WARNING: This page is about a different car, the 2018 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.

Refer to Wiring Diagram Power Distribution for schematic and connector information.

Normal Operation and Fault Conditions 

REFER to:DESCRIPTION AND OPERATION .

BCM DTC Fault Trigger Conditions 

DTC Description Fault Trigger Conditions
U300A:01 Ignition Switch: General Electrical Failure Sets when the BCM detects an invalid combination from the ignition switch input circuits, such as a voltage signal only from the ON-designated circuit, a voltage signal only from the START-designated circuit or a voltage signal from ACC and START-designated circuits at the same time.

Possible Causes 

scientia non olet · About LEMON Manuals