Differential Control Module Rear (DCMR): Removal

WARNING: This page is about a different car, the 2018 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Removal steps in this procedure may contain installation details.

With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting .
1. Disconnect DCMR electrical connector by disengaging the side locking tab and pulling on the harness.
2. Detach the wiring harness retainer and position aside.
Disconnect DCMR electrical connector and detach the wiring harness retainer.

Courtesy of FORD MOTOR COMPANY
Remove the bolts and the DCMR.
Torque: 13 lb.in (1.5 Nm)

Courtesy of FORD MOTOR COMPANY