LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1066 (Vehicle Dynamic Suspension System) >> Diagnosis And Testing >> Vehicle Dynamic Suspension >> Pinpoint Tests >> Pinpoint Test C : P1758:19 >> Notes

Pinpoint Test C : P1758:19: Notes

WARNING: This page is about a different car, the 2018 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.

P1758:19 

Refer to Wiring Diagram Vehicle Dynamic Suspension for schematic and connector information.

Normal Operation and Fault Conditions 

Using input from the height sensors and HS-CAN2 messages, the VDM provides a varying current to the damper solenoid valves. The VDM is programmed with an upper limit for this current. One or more of the height sensors failing internally and damage or modifications to the vehicle suspension may cause this DTC to set.

DTC Fault Trigger Conditions 

DTC Description Fault Trigger Conditions
P1758:19 Pressure Solenoid Control System Incorrect Current: Circuit Current Above Threshold This DTC sets in continuous memory if one or more of the damper solenoids requests a current greater than or equal to 1.3 amps continually for more than 2 minutes, 3 or more times during the same ignition cycle.

Possible Sources 

scientia non olet · About LEMON Manuals