LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1050 (Sunroof System (Service Information)) >> 60 Sunroof >> Sliding Sunroof >> Sunroof Seals, Removing And Installing >> Sunroof Seals, Removing And Installing, Sedan >> Procedure

Sunroof Seals, Removing And Installing, Sedan: Procedure

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Sliding Sunroof Panel -3- Removed.

GWWA60-0042Courtesy of AUDI OF AMERICA, LLC

-- Remove the panel seal -2- from the sunroof panel -3-.

-- Push the new panel seal into the sunroof panel -3- starting at rear of panel edge in center.

NOTE:

Coat The Edge Of The Panel With Soapy Water To Make It Easier To Install The Seal.

scientia non olet · About LEMON Manuals