Vehicles With High Gloss Roof Trim Molding:

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Roof trim molding and side trim molding removed.

-- Unclip the roof trim molding on the roof around the side window.

Courtesy of AUDI OF AMERICA, LLC

CAUTION:

Remove the upper >>C-pillar<< and >>D-pillar<< trim and secure the antenna connections with adhesive tape to the center of the window.

-- Route the cutting wire around the side window as shown in the illustration.

-- Secure ends X and Y in two pull handle from the :VAG1351 .

-- Pull cutting wire forward in direction of arrow -A- using sawing motions and cut through lower adhesive sealing material at side panel and at roof frame.

-- At the same time, the first the locating pin on the rear of the window glass and then the adhesive bead are cut through.

-- Then pull the cutting cord in the direction of the arrow -B- downward through the adhesive bead.

-- Remove the window glass from the window opening.