Engine Oil Cooler, Removing And Installing: Removing

WARNING: This page is about a different car, the 2018 Audi A6 Quattro, 2017 Audi A6 Quattro, and 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Drain the coolant. Refer to COOLANT, DRAINING AND FILLING .

-- Remove the plenum chamber bulkhead. Refer to BULKHEAD .

-- Release the catches in direction of -arrow-, remove the wiring duct -1- toward the rear and push upward.

Courtesy of AUDI OF AMERICA, LLC

-- Push the wires and hoses to the side.

Courtesy of AUDI OF AMERICA, LLC

-- Lift the clamp -1-, open the hose clamp -2-, and remove the coolant hose.

-- Remove the bolts -3- and -arrows- and remove the engine oil cooler -4- to the left side.