Oil Separator, Removing And Installing: Removing

WARNING: This page is about a different car, the 2018 Audi A6 Quattro, 2017 Audi A6 Quattro, and 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the upper coolant pipe. Refer to UPPER COOLANT PIPE, REMOVING AND INSTALLING .

-- Remove the Fuel Pressure Sensor -G247-. Refer to Fuel Pressure Sensor -G247-, REMOVING AND INSTALLING .

-- Remove the left and right connection -arrow-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -1-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the connection with the crankcase ventilation hose.

NOTE:

The illustration shows the installation position with the compressor installed.

Ignore item -2-.

-- Remove the bolts -2- and -arrows-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bracket -3-.

-- Push the wire and vacuum hoses to the side and remove the oil separator with cover.

NOTE:

Ignore item -1-.