Cell Phone Preparation Connector Assignment, MMI, 9ZF
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- GSM connection from Roof Antenna -R216-
- Connection block with four multi-pin connectors
- MOST Bus
- CVBS input from TV Tuner -R78- /DVD Changer - R161-
- 4-Pin Connector -T4dc- to the Front Information Display Control Head -J685-
- 4-Pin Connector -T4aa- to the External Audio Source Connection -R199-
- Not Assigned
- GPS connection from the Roof Antenna -R216-
NOTE:
Unlisted connector terminals are not assigned.
2 - Connection Block with Four Multi-Pin Connectors
- Not Assigned
- Not Assigned
- Wake UP to Multimedia System Control Head -E380-
- Not Assigned
- Switch-on signal to Telephone Baseplate -R126- /Cellular Telephone Amplifier -R86-
- Res MU to Multimedia System Control Head -E380-
- Ring-break Diagnostic Cable
- Not Assigned
- Not Assigned
- Microphone input (+) of Right Front Microphone -R141-, Microphone Unit in Front Roof Module -R164-
- Microphone input (-) of Right Front Microphone -R141-, Microphone Unit in Front Roof Module -R164-
- Not Assigned
- CVBS cable (-) for the Rearview Camera System Control Module -J772- /Peripheral Camera Control Module -J928-
- Not Assigned
- Not Assigned
- Microphone input (+) of Left Front Microphone -R140-, Microphone Unit in Front Roof Module -R164-
- Microphone input (-) of Left Front Microphone -R140-, Microphone Unit in Front Roof Module -R164-
- Not Assigned
- CVBS cable (+) for the Rearview Camera System Control Module -J772- /Peripheral Camera Control Module -J928-
- Not Assigned
All pins are connected to the External Audio Source Connection -R199-.
- LF-In Ground
- Right LF-In
- USB, +5 V
- USB, Ground
- iPod, ACC Power
- Detect
- Left LF-In
- LF-In Ground Shielding
- CVBS cable (+)
- CVBS cable (-)
- iPod data
- iPod data
9 - Switch-on signal to Telephone Baseplate -R126-
10 - Data from Multimedia System Control Head -E380-
11 - Data to the Multimedia System Control Head -E380-
12 - Terminal 31
13 - DIAG signal from Telephone Baseplate -R126-
14 - Res BT from Multimedia System Control Head -E380-
15 - Terminal 30
- Output
- Input
All pins are connected to the External Audio Source Connection -R199-.
- D (+)
- iPod recognized
- D (-)
- Ground
All pins are connected to the Front Information Display Control Head -J685-.
- LVDS (-)
- LIN
- LVDS (+)
- Ground