Distance Measurement

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Switch on the :VAS6350/2 .

The following display appears.

Courtesy of AUDI OF AMERICA, LLC

The display shows how to stop the :VAS6350/2 . Press the corresponding button.

Courtesy of AUDI OF AMERICA, LLC

Attach with Front Edge
Attach with Rear Edge

-- Hold the :VAS6350/2 -2- flush in the bracket on one side of the calibration board (attach with rear edge). The :VAS6350/2 -2- must sit securely on the bracket.

Courtesy of AUDI OF AMERICA, LLC

-- Press the measuring button briefly.

The laser switches on.

-- The laser beam from the :VAS6350/2 -2- must hit the lower, enlarged section of the paddle -1-.

If this is not the case, the paddles must be corrected accordingly via clamping screws on the :VAS6350/1 .

-- Use one hand to secure the :VAS6350/2 in the bracket on the Calibration Tool :VAS6350A while the laser beam is visible on the paddle.

-- Then press the measurement button for the distance measurement briefly.

-- Write down the value.

-- Repeat this measurement on the other side of the :VAS6350A in the same way for the rear wheel.

The distance value must be the same on both sides.

If values are not identical:

-- Align the :VAS6350A long enough so that both sides are identical.

Pay attention when aligning the :VAS6350A , that the :VAS6350/3 from the :VAS6350A strikes the center of the Audi rings and the indicator of the level remains centered. Adjust if necessary.