Rearview Camera -R189-, REMOVING AND INSTALLING, AVANT: Removing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
The Rearview Camera -R189- has a trailing cable. The vehicle wiring harness couplings are located in the rear lid.
-- Remove the lower rear lid trim panel. Refer to REAR LID LOCK TRIM PANEL, REMOVING AND INSTALLING .
-- Unlock and disconnect the connectors -1, 2 and 4- inside the rear lid.
The Rearview Camera -R189- is firmly attached to the handle button -3-.
-- Remove the nuts -arrows-.
NOTE:
Depending on the market, it may be necessary to remove the license plate or the license plate bracket.
-- Pull the handle button -3- with the Rearview Camera -R189- out of the retainer in the rear lid.