LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1036 (Engine Lubrication System (Service Information - CEUC, CRDB, CTGE, CWUB, CWUC)) >> 17 Lubrication >> Engine Oil Cooler >> Engine Oil Cooler, Removing And Installing >> Engine Oil Cooler, Removing And Installing, Front >> Installing

Engine Oil Cooler, Removing And Installing, Front: Installing

WARNING: This page is about a different car, the 2018 Audi S6, 2017 Audi S6, and 2016 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.

Install In Reverse Order Of Removal.Note The Following: 

NOTE:

Replace The O-Rings.

Secure All Hose Connections With Hose Clamps Of The Same Type As Those Equipped By The Factory.

-- Install the ribbed belt tensioner. Refer to RIBBED BELT TENSIONER, REMOVING AND INSTALLING .

-- Install the vibration damper. Refer to VIBRATION DAMPER, REMOVING AND INSTALLING .

-- Check the oil level. Refer to the appropriate service information.

scientia non olet · About LEMON Manuals