Overview - Ignition System
WARNING: This page is about a different car, the 2018 Audi S6, 2017 Audi S6, and 2016 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.
- Knock Sensor
- Cylinder bank 1 (right)
- Front Knock Sensor 1 -G61-
- Rear Knock Sensor 2 -G66-
- Removing and installing. Refer to KNOCK SENSOR, REMOVING AND INSTALLING .
- Bolt
- 25 Nm
- Tightening specifications affect function of Knock Sensor (KS)
- O-Ring
- Always replace
- Camshaft Position Sensor
- Intake side Camshaft Position Sensor -G40-
- Removing and installing. Refer to Camshaft Position Sensor -G40-, REMOVING AND INSTALLING .
- Exhaust side Camshaft Position Sensor 3 -G300-
- Removing and installing. Refer to Camshaft Position Sensor 3 -G300-, REMOVING AND INSTALLING .
- Bolt
- 9 Nm
- Spark Plug
- Tightening specification. Refer to appropriate service information.
- Replacement interval. Refer to Maintenance Tables.
- Ignition Coil
- Removing and installing. Refer to IGNITION COILS WITH POWER OUTPUT STAGES, REMOVING AND INSTALLING .
- Bolt
- 9 Nm
- Wiring Guide
- Bolt
- 5 Nm
- Engine Speed Sensor -G28-
- Removing and installing. Refer to Engine Speed Sensor -G28-, REMOVING AND INSTALLING .
- Bolt
- 9 Nm
- Bolt
- 9 Nm
- Camshaft Position Sensor
- Intake side Camshaft Position Sensor 2 -G163-
- Removing and installing. Refer to CAMSHAFT POSITION SENSORS -G163 - / - G301-, REMOVING AND INSTALLING .
- Exhaust side Camshaft Position Sensor 4 -G301-
- Removing and installing. Refer to CAMSHAFT POSITION SENSORS -G163 - / - G301-, REMOVING AND INSTALLING .
- O-Ring
- Always replace
- Bolt
- 25 Nm
- Tightening specifications affect function of Knock Sensor (KS)
- Knock Sensor
- Cylinder bank 2 (left)
- Front Knock Sensor 3 -G198-
- Rear Knock Sensor 4 -G199-
- Removing and installing. Refer to KNOCK SENSOR, REMOVING AND INSTALLING .