Knock Sensor 2 -G66-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2018 Audi S6, 2017 Audi S6, and 2016 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the right front wheel. Refer to WHEEL, CHANGING AND MOUNTING .

-- Remove the drive axle cover -1- in the right wheel housing.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the right engine mount. Refer to RIGHT ENGINE MOUNT, REMOVING AND INSTALLING .

-- Remove the nut -2- and free up the ground wire.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -arrows- and remove the right engine support -1-.

-- Disconnect the connector -4- from the starter by sliding the retainer back and pressing the release down.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the nut -3- and the battery positive wire from the solenoid switch.

-- Disconnect the connector -1-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -2- and then the Knock Sensor 2 -G66-.