LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1034 (Ignition/Glow Plug System (CEUC, CRDB, CTGE, CWUB, CWUC)) >> 28 Ignition/Glow Plug System >> Ignition System >> Knock Sensor, Removing And Installing >> Knock Sensor 2 -G66-, REMOVING AND INSTALLING >> Installing

Knock Sensor 2 -G66-, REMOVING AND INSTALLING: Installing

WARNING: This page is about a different car, the 2018 Audi S6, 2017 Audi S6, and 2016 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following: 

NOTE:

The tightening specification influences the function of the knock sensor.

-- Install the engine support and the right engine mount. Refer to RIGHT ENGINE MOUNT, REMOVING AND INSTALLING .

scientia non olet · About LEMON Manuals