Knock Sensor 1 -G61-, REMOVING AND INSTALLING: Removing
WARNING: This page is about a different car, the 2018 Audi S6, 2017 Audi S6, and 2016 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the Oil Pressure Switch/Reduced Oil Pressure Switch - F22- / - F378-. Refer to Oil Pressure Switch -F22 - / Reduced Oil Pressure Switch -F378-, REMOVING AND INSTALLING .
-- Remove the bolt -arrow- from the front coolant pipe.
-- Remove the ribbed belt tensioner. Refer to RIBBED BELT TENSIONER, REMOVING AND INSTALLING .
-- Unscrew bolt -arrows- for the generator approximately six turns.
-- With a hammer carefully hit the bolt heads, to loosen the bushings on the generator mount.
-- Remove the bolts completely.
-- Push the generator as far forward as possible.
-- Remove the bolt -2- and then the Knock Sensor 1 -G61-.
-- Disconnect the connector -1-.