Engine Speed Sensor -G28-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2018 Audi S6, 2017 Audi S6, and 2016 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the rear noise insulation. Refer to NOISE INSULATION .

Vehicles with an s-tronic Transmission 0B5:

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -arrow- from the right coolant pipe on the transmission.

NOTE:

Ignore item -1-.

-- Remove bolts -arrows- and move the ATF cooler slightly to the side.

Courtesy of AUDI OF AMERICA, LLC

Continuation for All Vehicles:

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -2-.

-- Remove the bolt -1- and the Engine Speed Sensor -G28-.